Installation polycarbonate

Step 1: Prepare your equipment — You will need to make sure that you have all of the equipment needed for this task. Step 2: Follow safety measures — Before you begin, it is important to follow all safety measures. Step 3: Prepare your sheets the right side up — Lay the sheets out side by side with their right sides up.

Step 4: Cut the sheets with your needed sizes — Use the shears to cut off any excess material. Step 5: Seal your Polycarbonate roofing — Use the breathing tapes to seal all of your seams. Step 6: Fix the installed Polycarbonate roofing — Use the fixings to secure your roofing in place. Polycarbonate Roofing is one of the most durable options for greenhouse coverings and skylight covers on the market today. While polycarbonate is typically strong enough to resist breakage from snow or ice, the panel may bow if it is installed too close to a roof edge where it becomes a fulcrum point.

There are many benefits of installing polycarbonate roofing. Polycarbonate roofing is a rotary molded, corrosion resistant product developed for low slope applications including flat roofs.

Polycarbonate Roofing can be used as an energy conserving, translucent exterior cladding which provides natural lighting within the building or structure that it covers. Polycarbonate roofing products provide long lasting durability and weather resistance thanks to their strong and multi-directional top layer.

When fastening screws, do not tighten below the surface of the panel. Allow for proper expansion in all drilled holes. Glazing sheets should be joined using either aluminum profiles from Rimol Greenhouse Systems or polycarbonate profiles from Co-Ex.

For triple wall polycarbonate, use solid foil tape at the tops of the sheets to seal out water and insects, and foil vented tape at the bottom of the sheets to seal out any insects and allow condensation to drain out of sheets. Do not over-bend polycarbonate sheets.

Minimum bending radius is times the thickness of the panel. When joining sheets of corrugated polycarbonate, allow for one corrugation to overlap. How To's All How To's. Handling Polycarbonate All polycarbonate is supplied with a protective film which should be kept on until the panel is fastened. Hardware use Use screws with neoprene bonded washers to fasten polycarbonate to greenhouse.